PHAT PS3 Power/Eject board ribbon cable repair!

Share/Bookmark

I have begun this post since I found no information anywhere about ways to repair these ribbon cables when you or someone else thoughtlessly forces the cable back in and pops the cable halfway down the calls.

When your ps3 powers up before you pull it apart put you get no lights after putting it back with each other, its apparent that you have actually damaged the cable television. When yo do a YLOD repair, Like.

SYMPTOMS:.

  • PS3 shows no standby red light and does not react to buttons pushes.
  • PS3 was showing lights before being taken apart.

SATISFY DUAL CHECK THAT YOU HAVE CONNECTED THE CABLE TELEVISION CORRECTLY BEFORE TRYING THIS, YOU MAY SIMPLY HAVE NOT HAVE THE CABLE IN PROPERLY !!!

I’ts not functioning to start with so you have absolutely nothing to get rid of! Not my negligence if you create more damage to your ps3 or on your own, Doing this at your very own threat!

REQUIREMENTS:.

  • Ribbon Cable television with busted contacts.
  • Sharp knife or scissors.

Everything you need to do is reduce around 2-3mm from the end of the get in touches with. An excellent method to do this is to snip 1mm from completion and examination in the ps3. If it doesn’t function after that snip one more 1mm from completion and retest. After that just shave the end of the tiniest part by part until it works again.

Image to come soon.

I have actually successfully done this to 4 ps3’s and has actually functioned completely in each instance.

I wish this details assists.